Numéro
J. Phys. Colloques
Volume 51, Numéro C4, Juillet 1990
Multilayer Amorphisation by Solid-State-Reaction and Mechanical Alloying
Page(s) C4-79 - C4-85
DOI https://doi.org/10.1051/jphyscol:1990409
Multilayer Amorphisation by Solid-State-Reaction and Mechanical Alloying

J. Phys. Colloques 51 (1990) C4-79-C4-85

DOI: 10.1051/jphyscol:1990409

THERMODYNAMIC EVALUATION OF THE Cu-Ti SYSTEM IN VIEW OF SOLID STATE AMORPHIZATION REACTIONS

L. BATTEZZATI1, M. BARICCO2, 3, G. RIONTINO1, 3 et I. SOLETTA4

1  Dipartimento di Chimica Inorganica, Chimica Fisica e Chimica dei Materiali, Università di Torino, Italy
2  Instituto Elettrotecnico Nazionale Galileo Ferraris, Torino, Italy
3  INFM, Unita' di Ricerca di Torino, Italy
4  Dipartimento di Chimica, Università di Sassari, Italy


Résumé
La description thermodynamique du sistéme Cu-Ti est reconsidérée, car les calculs de la littérature, bien que donnant une bonne représentation du diagramme de phase, ne prevoient pas la possibilité de l'amorphisation. Une nouvelle courbe d'ènergie libre pour la phase liquide est proposée, prenent en compte un excès de chaleur spècifique de mélange. Cette dernière quantité a été obtenue pour quelques compositions de la différence entre la chaleur de fusion et la chaleur de cristallisation de rubans amorphes. On montre que la stabilité de la phase liquide croît lorsque la température décroît. Les courbes Tg et T0 pour Cu-Ti sont calculées, et l'intervalle d'amorphisation discute.


Abstract
The thermodynamic description of the Cu-Ti system is revised as current evaluations of it, while giving a reasonable fit to the phase diagram, do not predict the possibility of amorphization. A new free energy curve for the liquid phase is derived accounting for an excess specific heat of mixing. This latter quantity has been obtained for a few compositions from the difference between the heat of fusion and the heat of crystallization of melt spun ribbons. An increase in stability of the liquid phase on decreasing temperature is shown. Tg and T0 curves for Cu-Ti are calculated and the glass forming range is discussed.