Numéro |
J. Phys. Colloques
Volume 46, Numéro C6, Septembre 1985
MMA' 85Europhysics Conference on Magnetic Materials for Applications |
|
---|---|---|
Page(s) | C6-49 - C6-53 | |
DOI | https://doi.org/10.1051/jphyscol:1985608 |
Europhysics Conference on Magnetic Materials for Applications
J. Phys. Colloques 46 (1985) C6-49-C6-53
DOI: 10.1051/jphyscol:1985608
FACTORS INFLUENCING PERPENDICULAR ORIENTATION OF GAMMA IRON OXIDE MEDIA
C.D. Wright1 et B.K. Middleton21 Dept. Physics, Salford University, Salford M5 4WT, U.K.
2 Dept. Elec. Eng., Manchester Polytechnic, Manchester M1 5GD, U.K.
Résumé
Cet article décrit une étude de l'orientation perpendiculaire des particules de γFe2O3 déposées sur une bande. Le dépôt s'effectue dans des conditions standard mais avec l'adjonction d'un champ magnétique d'orientation. L'intensité du champ varie de zéro à 3kOe, pour un rapport d'oxide sur encapsulant de 15% à 50%. L'anisotropie est déterminée a l'aide de mesures hystérétiques (VSM) dans les trois directions. De plus, l'orientation magnétique est obtenue par M-H à différents angles. Une bonne orientation magnétique a été obtenue (Sy = 0.7, Sy/Sx = 1.6) mais les échantillons préparés sous un champ continu présentaient une surface rugueuse. En employant un champ alternatif d'orientation, la rugosité sort améliorée sans pour disparaître. Des solutions alternatives sont discutées.
Abstract
This paper describes an investigation into the perpendicular orientation of γFe2O3 recording media via standard coating techniques in association with a vertical orienting field. Samples were prepared over a range of orienting field strengths from zero to 3kOe, and for a range of oxide/binder ratios from 15% to 50%. The resulting anisotropy was assessed by VSM measurement of hysteresis properties in the longitudinal, perpendicular and transverse directions. Additional orientation information was obtained by M-H measurements at angles intermediate to the planar and perpendicular axes. The degree of alignment produced in the study was good (Sy = 0.7, Sy/Sx 1.6) but specimens prepared by straightforward D.C. or, entation had rather rough surfaces. This characteristic roughness was reduced, though not completely eliminated, by using A.C. in place of D.C.. Alternative strategies for improving surface quality are discussed.