Issue
J. Phys. Colloques
Volume 48, Number C8, Décembre 1987
Fifth European Conference on Internal Friction and Ultrasonic Attenuation in Solids
Page(s) C8-451 - C8-456
DOI https://doi.org/10.1051/jphyscol:1987869
Fifth European Conference on Internal Friction and Ultrasonic Attenuation in Solids

J. Phys. Colloques 48 (1987) C8-451-C8-456

DOI: 10.1051/jphyscol:1987869

HIGH TEMPERATURE INTERNAL FRICTION OF Ni-20 wt% Cr

R. SCHALLER1, J.J. AMMANN1 et F. COSANDEY2

1  Institut de Génie Atomique, Ecole Polytechnique Fédérale de Lausanne, CH-1015 Lausanne, Switzerland
2  The State University of New Jersey, RUTGERS, Department of Mechanics and Materials Science, PO Box 909, Piscataway, NJ 08854, USA


Résumé
Le spectre de frottement intérieur haute température des alliages Ni-Cr 20% est essentiellement caractérisé par un pic de relaxation (à 1000 K, 1 Hz) superposé à une montée exponentielle du fond avec la température. Un phénomène d'hystérèse réversible apparaît sur le pic entre les courbes obtenues à la montée et à la descente en température. Cette hystérèse est beaucoup plus forte pour les échantillons contenant 180 ppm Ce. Dans ce cas, on observe de forts accroissements du frottement intérieur au-dessus de la température du pic, qui peuvent être corrélés à une sugmentation de la ductilité à haute température des alliages Ni-Cr, sous l'effet d'adjonctions de Ce.


Abstract
The high temperature internal friction spectrum of Ni-20 wt% Cr alloys is mainly characterized by a relaxation peak (at 1000 K for 1 Hz) superimposed to a background increasing exponentially with the temperature; A reversible hysteresis appears in the peak temperature range between the curves measured upon heating and upon cooling. This hysteresis is much stronger in specimens containing 180 at ppm Ce. In this case, strong increases of the internal friction are observed at temperatures higher than the peak one. The high internal friction value measured upon cooling can be correlated with and increase of the high temperature ductility in Ni-Cr alloys, which is due to Ce additions.